Certified Attic Mold Removal
for Hudson Attic Spaces

Two root causes account for most Hudson attic sheathing mold: improperly terminated exhaust fans and blocked/insufficient soffit-to-ridge ventilation. Both create the same condition — warm moist air in the attic unable to exit, condensing on cold sheathing surfaces. We find which one (or both) is present in your Hudson, NY attic before proposing any treatment scope.

Not necessarily. OSB sheathing commonly contains sapstain organisms from the lumber mill — these blue-black fungi are present in the wood at installation and are not active mold growth requiring remediation. Sapstain persists regardless of the current moisture condition, doesn't pose the same air quality concerns as active mold, and costs homeowners significant money in unnecessary remediation when misidentified. We distinguish between sapstain and active mold using MC% readings (active mold requires elevated MC to persist; sapstain doesn't) and targeted lab sampling from suspected active areas before scoping any treatment.

IICRC guidelines permit in-place treatment of surface mold on structurally sound sheathing — defined as material where structural integrity is maintained (MC below threshold when dry, no physical delamination, no loss of rigidity from fungal digestion). Treatment consists of HEPA vacuuming to remove loose spore material, EPA-registered fungicide application, and penetrating borate for ongoing inhibition. Sections with structural delamination or through-penetration require replacement, assessed individually. Full sheathing replacement across the entire attic is rarely warranted and should require clear justification based on section-by-section structural assessment.

Our initial attic assessment traces every exhaust fan duct from its housing to its termination. Improperly terminated fans are identified and rerouting is specified in the remediation scope. You'll know definitively after our assessment whether fan termination is contributing to your Hudson attic mold problem.

We treat wood structural components only — sheathing and rafters — and do not apply products to roofing materials. Our treatment products have SDS sheets available on request, and we can provide these to your roofing material manufacturer representative for verification of compatibility. Most manufacturers don't restrict attic wood treatment by qualified contractors, but if you have a specific manufacturer warranty question, we recommend confirming directly before scheduling work.